Draytek Vigor VigorAccess IVD Bedienungsanleitung PDF herunterladen (Seite 12)

Version: 1.0

Quick Start Guide for VigorAccess IVD

S How to Upgrade Firmware

Users can use the following commands to upgrade new firmware. Make sure you have prepared a TFTP

server on a host and put the firmware (ivd.all for example) in the right directory of the TFTP server

Command Description

Admin> system

Enter system directory

Admin/system> upgrade <ServIP>

Execute the firmware upgrading

Admin/system> reboot

Reboot the Controller to run the new firmware

Admin/system> basicInfo

After rebooting, check the firmware version

S How to Save Configuration

Users can use the following command to save the current configuration.

Command Description

Admin> commit

Save the configuration

S How to Enable/Disable the Switch Port

Users can use the following commands to enable or disable the port on Controller. By default, G1 to G6

are off, but G0 and UP-G are on. If users find that when they connect the subtend slave machines to the

master machine but the connection cannot be constructed, check the link status of the port connected to

the master machine is enabled.

Note: Ports G1 to G6 will be on with default if the DSL F/W version is above V2.10.2.6.

Command Description

Admin> system

Enter system directory

Admin/system> link_state -s

Display the current status of all ports

Admin/system> link_state -m <IntfName>

on/off

Turn on/off of the specific port

S How to Connect to DSL Module

Users can login to DSL module in master or slave units using the following command. Once entering into

DSL module, the command described in Part II can be used.

Command Description

Admin> dsl

Display the current connectivity with DSL modules

Admin> dsl –c

Admin> dsl –m

Admin> dsl –s <salveId>

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 36 37

Keine Kommentare

Draytek Vigor VigorAccess IVD Bedienungsanleitung Seite 12