Draytek Vigor2910 Series Bedienungsanleitung Seite 3

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 5
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 2
802.11b & 802.11g Compatibility
802.11g Super-G Wireless LAN (Total bandwidth up to 108Mb/s)
WEP & WPA Wireless Encryption
WDS - Wireless Distribution System for expanding wireless networks
Optional Higher-Gain Aerials
Wireless Security Features :
WEP, WPA and WPA2 Wireless Security & Encryption
WLAN Isolation - Isolate WLAN from wired LAN
SSID Stealthing
Restricted access list for clients (by MAC address)
Time Scheduling (WLAN can be disabled at certain times of day)
802.1x User Authentication (via Radius Server, EAP-TLS Mode)
VoIP
Voice over IP
The Vigor2910VG provides twin phone ports for VoIP (Voice-over-IP). VoIP enables you to use your
existing broadband capacity to carry regular voice calls to suitably equipped remote sites, for example
another Vigor VoIP enabled router or to any other compatible hardware/software products, worldwide. The
Vigor2910
VG supports the industry standard 'SIP' system for compatibility with other vendors' produdcts.
The calls between the two sites in the example above are, of course, free of charge because they are making
use of your existing always-on ADSL connection, but cost isn't the only advantage; using VOIP means that
you have additional call capacity in your home or office, without tying up your regular phone line. Using a
VoIP-PSTN gateway service, such as DrayTEL you can also fully integrate with the PSTN, making and
receiving calls to and from any regular phone number, worldwide.
2nd WAN
Secondary WAN Port
The primary 'WAN' interface (the connection to
the outside world) is 10/100BaseT Ethernet. This
can connect to any Ethernet based router IP or
Internet feed which might typically be fed via
Leased Line, cable modem, ADSL, Satellite system
- anything which is then terminated in Ethernet.
In addition, one of the LAN Ethernet ports can be
selected as a secondary WAN (Internet) Interface.
The second interface can be used as the primary
interface, backup failover for the primary WAN
port, load balancing or just for increased total
bandwidth. This allows you to use two Internet
feeds simulataneously to provide higher total
capacity, or rule-based routing over two feeds
(load balancing). If you do not have a second
WAN feed, you can use the 2nd WAN port as a
regular LAN port instead.
Page 3 of 5 ©2008 SEG. Reproduction prohibited without written permission. 11.06.09
Seitenansicht 2
1 2 3 4 5

Kommentare zu diesen Handbüchern

Keine Kommentare