Draytek VigorAP 700 Betriebsanweisung PDF herunterladen (Seite 63)

VigorAP 700 User’s Guide

Chapter III: Troubleshooting

If you found the access point is working improperly or stops responding to you, don’t panic!

Before you contact your dealer of purchaser for help, please read this troubleshooting first.

Some problems can be solved by yourself within a short time!

Scenario Solution

Access point is not

responding to me when I

want to access it by web

browser

a. Please check the connection of power cord and network

cable of this access point. All cords and cables should be

correctly and firmly inserted to the access point.

b. If all LEDs on this access point are out, please check the

status of A/C power adapter and make sure it’s correctly

powered.

c. You must use the same IP address section which access

point uses.

d. Are you using MAC or IP address filter? Try to connect

the access point by another computer and see if it works.

If not, please perform a hard reset (pressing Reset/WPS

button).

e. Set your computer to obtain an IP address automatically

(DHCP), and see if your computer can get an IP address.

f. If you have done a firmware upgrade and this happens

still, contact your dealer of purchase for help.

g. If all above solutions don’t work, contact the dealer of

purchase for help.

Can’t get connected to

VigorAP 700

a. If encryption is enabled, please check WEP or WPA

passphrase settings on your wireless client again.

b. Try to move closer to VigorAP 700.

c. Unplug the power plug of access point, and plug it back

again after 10 seconds.

d. If all LEDs on this access point are out, please check the

status of A/C power adapter and make sure it’s correctly

1 2 ... 58 59 60 61 62 63 64 65 66 67

Keine Kommentare

Draytek VigorAP 700 Betriebsanweisung Seite 63