Draytek Vigor3300 Series Bedienungsanleitung PDF herunterladen (Seite 35)

-p It is used for editing the protocol used by selected filter rule.

-b It is used for editing the action of “block or pass” of selected filter

rule.

-d It is used for configuring the direction of selected filter rule.

-f It is used for editing the fragmented packets setting of selected filter

rule.

-a It is used for editing the activation of selected filter rule.

GroupId Enter the name of the group that you want to add new rules.

RuleIndex Enter the index number of the filter rule that you want to change.

Source/Subnet Enter the source IP address with subnet mask.

Op1 Enter the following character to specify operators for source port.

0: = ;

1: != ;

2: > ;

3: < ;

4: between

Sourceport1 Enter the start port value for source port.

Sourceport2 Enter the end port value for source port.

When you set <Op1> with1~3, you have to set the same value for

<Destinationport2> and <Destinationport1>.

Destination/Subnet Enter the destination IP address with subnet mask.

Op2 Enter the following character to specify operators for destination port.

0: = ;

1: != ;

2: > ;

3: < ;

4: between

Destinationport1 Enter the start port value for destination.

Destinationport2 Enter the end port value for destination. When you set <Op2> with

1~3, you have to set the same value for <Destinationport2> and

<Destinationport1>.

Protocol Enter the number listed below to specify certain protocol for filter

rule.

0: TCP ; 1: UDP ; 2: ICMP

Blockop Enter the number listed below to specify certain action executed when

packets match the rule.

0: Block

1: Pass

2: Block if no future match

3: Pass if no future match

Nextgroupid Enter the group name that you want to specify as next filter group.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 122 123

Keine Kommentare

Draytek Vigor3300 Series Bedienungsanleitung Seite 35